![]() These pressure units are defined as being exactly equal to 1/760 of one standard atmosphere (101,325 Pa), which can be easily incorporated into calculations simply as 101325/760 Pa which is approximately equal to 133.322 pascals. These pressure units which belong to the metric unit system where the bar is defined as being exactly equal to 100,000 pascals. These pressure units belong to the SI measurement system where the pascal is derived from the SI units by the following formulas: 1 kg Density of mercury at 0 deg C is 13,595.1 kg/m³.Density of pure water at 4 deg C is 1000 kg/m³.Standard acceleration due to gravity of 9.80665 m/s².The above manometric pressure units assume the following in their derivation and although they are not physical constants they have been accepted as popular conventions and are used universally: The use of manometric units is discouraged by national standard organisations because they do not precisely represent the true pressure and there are differing conventions used for the temperature and density of the liquid which can lead to variation in accuracy. The physical assumptions that these conversions factors are based can be found at the bottom of this section. Since the pressure of the fluid column can vary with changes in liquid density and local gravity it is important to quantify these factors when using these units. The pascal is the SI unit for measuring pressure. Each manometric pressure unit is shown with its equivalent value converted into pascals (Pa). ![]() The following units are known as manometric pressure units and are derived from the pressure exerted by a column of liquid under the acceleration of earth’s gravity. Numbers which include on the end are rounded. These units have an internationally agreed definition for the conversion factor, some have an exact value with very few digits, while others have a lot of digits and may vary very slightly between reference sources, depending on the level of precision used when calculating the values. The following list shows each pressure unit and its equivalent value converted into pascals (Pa). E/P & P/E conversion for voltage and pneumatic signal control instrumentation.I/P & P/I conversion for current and pneumatic signal control instrumentation.Altitude to pressure conversion from feet or metres to mbar, psi, mmHg & inHg.Vacuum conversion for % vac, mbar, hPa, psi, inHg, mmHg & Torr.Barometric conversion for mbar, hPa, psi, inHg, mmHg & Torr. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |